1000GTIL2-LCD—-share the same program, but no clamp sensor would be sent if you choose model 1000G2-LCD. Latest updated program enable customers using battery discharge power mode. This is the 2. The first generation GTIL must be used with an additional limiter module, we also add an switch button to enable. The inverter either can work at limit mode or at normal grid tie mode. Generation GTIL, we integrated the limit function inside the GTI. Customer install inverter far away from the main circuit breaker, we also enable the 2. GTIL work with stand-alone limiter, we call this-external. For sure, the inverter can work under normal Grid tie-no limit mode, just set on the nice LCD and save your setting. Max input DC voltage. Peak power tracking voltage. 47.5-51.5 for 50hz; 59.3-60.5 for 60hz. Just for AC output. 20’C — +85’C. Settings Explainations on the LCD of the 2. The GTIL including various functions, all functions should configurate on the LCD setting page. Please see below explainations. Limit Mode:External limiter and Internal limiter are settable. Limit mode+External limiter both selected means work under external limiter mode. Limit mode+Internal limiter both selected means work under external limiter mode. LCD back light:Select it, Lcd will always on. Unselect it, Lcd will auto turn off after about 10s without any action on lcd button. Press any of the button to light lcd again. Remote Num:while using with wifi plug for monitoring, set by 1. While using with the WIFI-RTU(one rtu can monitoring multiple inverters), set monitored inverter numbers. Bat or solar limited current mode:This function is usable while using with battery. The setted voltage will be the cut off voltage, this means while battery discharged to the setted voltage point or below setted point, inverter will auto disconnect from the battery and stop operating. This can prevent the battery from over discharged. The setted current means inverter will discharge the battery at this current level. Mppt function of the inverter will auto invalid when working under this setting. Set is 0.1V/step. Set is 0.1V/Step. The 22-65V type inverter will start up at 25V, and 45-90V type inverter will start up at 49.5V, after start, inverter can still work until 22v or 45v. Current sensor Orientation:Please check the current flow direction arrow on the sensor before use, make sure the connection is correct. Otherwise, inverter will not start up at limit mode. Negative power under AC voltage means power overflow to the grid. Positive means power come from the grid. Clamp Sensor with 2m cable—1pcs;(only available for 1000GTIL2-LCD). The item “1000W New Grid Tie Inverter 22-65V or 45-90V DC LCD display MPPT Pure Sine Wave” is in sale since Thursday, June 08, 2017. This item is in the category “Home & Garden\Home Improvement\Electrical & Solar\Alternative & Solar Energy\Chargers & Inverters”. The seller is “sunhome910″ and is located in shanghai. This item can be shipped to North, South, or Latin America, all countries in Europe, all countries in continental Asia, Australia.

• Brand: Tricorpower
• MPN: Does Not Apply
• Country/Region of Manufacture: China