New developed grid tie inverter(second generation) with different design structure, enable better and stable operation quality. With much better output pure sine waveform and better PF Value. The inverter is integrated with internal limiter and external limiter function which can prevent excess power from going to the public grid. Select the internal limiter mode, inverter will work under limiter mode, output power of the inverter will be determined by load power. Select the external limiter mode, inverter need a external limiter module working with it. Max input DC voltage. Peak power tracking voltage. 47.5-51.5 for 50hz; 59.3-60.5 for 60hz. Just for AC output. 20’C — +85’C. Settings Explainations on the LCD of the 2. The GTIL including various functions, all functions should configurate on the LCD setting page. Please see below explaination. Limit Mode:External limiter and Internal limiter are settable. Limit mode+External limiter both selected means work under external limiter mode. Limit mode+Internal limiter both selected means work under external limiter mode. LCD back light:Select it, Lcd will always on. Unselect it, Lcd will auto turn off after about 10s without any action on lcd button. Press any of the button to light lcd again. Remote Num:while using with wifi plug for monitoring, set by 1. While using with the WIFI-RTU(one rtu can monitoring multiple inverters), set monitored inverter numbers. Bat or solar limited current mode:This function is usable while using with battery. The setted voltage will be the cut off voltage, this means while battery discharged to the setted voltage point or below setted point, inverter will auto disconnect from the battery and stop operating. This can prevent the battery from over discharged. The setted current means inverter will discharge the battery at this current level. Mppt function of the inverter will auto invalid when working under this setting. Set is 0.1V/step. Set is 0.1V/Step. The 22-65V type inverter will start up at 25V, and 45-90V type inverter will start up at 49.5V, after start, inverter can still work until 22v or 45v. Current sensor Orientation:Please check the current flow direction arrow on the sensor before use, make sure the connection is correct. Otherwise, inverter will not start up at limit mode. Negative power under AC voltage means power overflow to the grid. Positive means power come from the grid. Clamp Sensor with 2m cable—1pcs;(only available for 2000GTIL2-LCD). Wifi Port for MPPT 1000W/2000W NEW SUN Solar/Wind Grid Tie Inverter Extra cost of 75usd required if. NOTE : this WIFI port must be ordered with 2nd Generation Grid Tie Inverters together. NOTE : It will be built-in side the inverter. Russian buyers were required to fill in the full name; Brazilian buyers are required to leave CPF/CPNJ Number; Chilean buyers are required to leave RUT number. All return products should be in original package with all accessories included. We stand behind our products so you are always covered! The item “2000W LCD Solar Grid Tie Inverter, MPPT pure sine wave built-in limiter optional” is in sale since Thursday, May 10, 2018. This item is in the category “Home & Garden\Home Improvement\Electrical & Solar\Alternative & Solar Energy\Chargers & Inverters”. The seller is “sunhome910″ and is located in Shanghai. This item can be shipped to North, South, or Latin America, all countries in Europe, all countries in continental Asia, Australia.

• Brand: Ecopower
• MPN: Does Not Apply
• Country/Region of Manufacture: China