2000W on Grid Tie Inverter with Limiter Controller for 3 Phase 48V Wind Turbine. Max Efficiency:>92% MPPT Efficiency:99%. AC 100V 110V 120V 220V 230V 240V 50hz 60hz. NEW 1000W Wind Power Grid Tie Inverter. Low cost and easy installation. Directly connect to three phase wind turbine. Much better output waveform compare with similiar GTI. Improving the efficiency of the entire wind power system. Overload protection, Anti-island protection. Short-circuit protection/Reverse polarity protection. AC output voltage and current THD. Input AC/DC Voltage Range. AC Output Voltage Range. 90-130V / 190VAC 260VAC. Dimensions (W x H x D). (1) (2) Dump load resistor connection Terminal. This terminals will connect to the dump load resistor. (3) AC socket, This socket will connect the inverter to the public grid via the AC cable. This terminals will connect to the wind turbine. The Inverter display can show many information, The main interface of the display and the icons explainations are show above. The inverter also integrate with internal limiter and external limiter function which can prevent excess power from going to the public grid. Select the internal limiter mode, inverter will work under limiter mode, output power of the inverter will be determined by load power. Select the external limiter mode, inverter need a external limiter module working with it. For more details about the limiter function, pls contact supplier. This function only useful with limiter type inverter. In this interface, the display shows real time power, PV input voltage, inside temperature, date and time. Clock And Date Setting. Set the clock and date in this page, save the setting before exit. Notes: Save the setting after you reconfigurate the working mode or backlight setting. Notes: Battery Discharge Current Mode And Battery Discharge Power Mode are not developed yet for this wind inverter. This interface will show the real time grid waveform. The grid voltage and frequency also will show in this interface. The energy interface will show the power generation curve everyday. Today KWH and Total KWH are also show in this page. AC Output Current Waveform and PF Test Of 2000W Model. Tested 2000W model at nearly full load, Output current waveform shows good pure sine wave in oscilloscope, PF value also shows in good result, 99.8% PF value. Advanced patented technology, MPPT efficiency is higher. High-quality imported components, more stable quality, lower failure rate. Significantly longer life, more than 10 years. Each inverter need to pass twice testing (20 hours) before leaving factory. Combination of SGPV does not interact. Improving the efficiency of the entire solar power system. No(Follow-up Tracking information will not be generated until the package arrives at the destination country). We will reply you within 24 hours. Feedback is important to us, we will leave positive to our customers. We understand the concerns and frustrations you might have, and will do our endeavor to resolve the issues. Please give us the opportunity to resolve any problem.