All In One Charge Controller Board. With 500 Watt Grid Tie Inverter. And 2500 Watt 24VDC Aims Power Inverter. This all in one charge controller board includes. (1) 440 Amp 10,000 Watt charge controller. (1) 200 amp fuse and holder. (1) 500 Watt Grid Tie Inverter. (1) DC to AC modified inverter 24 Volt 2500 Watt model. Completely pre-wired and ready to connect to your batteries with heavy duty fine stranded copper cable, tinned copper lugs, and dual wall heat shrink. Due to high customer demand, we’ve now added a 500 watt grid tie inverter as a diversion load. The grid tie inverter plugs into any 120 volt AC 60 hertz grid power connected wall receptacle (outlet). The DC to AC power inverter connects directly to your battery bank allowing you to power up 120 volt AC devices directly. In addition, the DC to AC Aims Power Inverter works as a’back-up’ or’stand-alone’ unit providing you with another source of free power whether the grid is working or not. Being able to run lighting, emergency equipment, and keeping your refrigerator cold when the grid is down is a valuable benefit! If you do not have grid power, see our other All In One Charge Controller Boards. For stand alone or remote power. We’ve made some important modifications to the assembly to make the grid tie inverter operate and to operate safely and reliably. The grid tie inverter alone cannot power devices directly. It must be plugged into a wall outlet connected to grid power. The optional DC to AC power inverter can, however. We recommend 250 to 1000 watts total of 24 volt solar charging panels on small or medium sized battery banks and up to 3,600 watts on larger battery banks. You can add additional grid tie inverters in parallel with the existing one. Do not exceed 1,500 watts of inverter output into any one wall outlet. The charge controller will come preset to disconnect the incoming solar power when the batteries are full therefore if the electric grid power is OFF you will not overcharge your batteries. This is important because the grid tie inverter must’see’grid power ON to feed power to it. The charge controller will still however go into a diversion cycle lasting up to 5 minutes each time. Because grid power is not 100% reliable. We are unable to allow the connection of wind turbines directly to this control board. However you may use an additional charge controller of suitable size and with its own diversion load to connect wind turbines to the same battery bank. This will help fill the batteries even faster and can provide valuable power at night. Even though the grid tie inverter is connected and prewired to the control board, it is not UL1741 listed. This controller board is simple to install, but, if in doubt, hire an electrician to help you. Below is an inside look at the All In One. Some of the key features of this controller are. Microprocessor controlled — This is very important for both stability and functionality. User changeable settings — Several controllers on the market set the dump level, and that’s that! Works directly with 12, 24 or 48 volt systems. – The relay contacts can handle open collector voltages of up to 120 volts. High Contrast LED battery voltage. Several controllers do not tell you what’s going on – This one does! High Contrast LED turbine amperage meter. Meters can be shut using the on/off switch. Two factory installed, fully wired D/C breakers and disconnects. Entire unit is wired and ready to go for both wind and solar. – Ever wonder if your controller & load are working OK? Large (8″ x 12″) solid steel enclosure, with multiple conduit knockouts. Large enough terminal blocks that you can actually terminate large wire See notes below. The electronics are fully isolated from the enclosure, no ground loops. Draws almost no energy while monitoring (all electronics must use some power, to work — this is a miser). Some specifics about the points made above. The microprocessor is the heart of the controller. It is given the battery voltage and the user changeable trip points. This information is analyzed and acted upon. The Battery level is checked, and based on that info. The Green LED flashes or is illuminated as follows. (One) Flash indicates the battery is less than 12 volts (12 volt system – Double for 24 etc). (Two) Flashes indicates the battery is 12 to 12.5V. (Three) Flashes indicates the battery is 12.6 to 13v. (Four) Flashes indicate the battery is 13.1 to 13.5V. (Five) Flashes indicates the battery is above 13.5V but less than 13.9V (Settings are adjustable). Steady green means the battery is full. The red LED is illuminated when the battery is being dumped at 14.5v or the charge source diverted. The dump remains active for a minimum of 5 seconds, at which time it is checked by the microprocessor. If battery voltage drops below the “Dump Cancel ” level, the dump is disabled, otherwise the dump is continued and rechecked every 5 seconds. Settings are user changeable! By simply turning a simple potentiometer with a small screwdriver, you can quickly adjust the trip point. – 10,000 watts!! — This is a MONSTER controller. 150 amp heat activated breakers have been installed to limit continuous current to 150 amps. Key features of AIMS 2500 Watt Power Inverter. 2500W max continuous power. Volt meter on front panel to monitor your battery voltage. Watt meter on front panel. LED indicator green/red that monitors ready/fault. Dual ac receptacle with protective rubber covers. Dual cooling fan operation Internally fuse protected. Ac output short circuit protection. Auto reset on most fault conditions. Aluminum case for optimal cooling. Pre-wired for remote on/off switch. Free 1 year tech support. This inverter is an excellent choice for our customers who currently have a 24 volt DC power source. AIMS offers all the great features found on the 12 volt version and includes them with this inverter. Some of these great features include digital bar graph style display gauges, thermally controlled fan, and isolated ground neutral. The display gauges offer immediate information regarding your inverter system. Dual bar graph style meters boast red, yellow, and green lights for a quick reference to your system’s condition. The cooling fans are thermally controlled and only operate when needed based on temperature. The design saves battery power since the fans will not run all the time. Whether you need reliable power for a bus/coach that has a 24 volt system or an off grid cabin that has a 24 volt battery bank connected to solar panels, this inverter is a great option. Continuous output power: 2500 Watts. Surge power capability (peak power): 5000 Watts. Use our 150 amp inline fuse. Dc input / operating voltage: 20 to 30 Volts. Output voltage: 120 Volts ac +/- 10%. Output wave form: modified sine wave with phase correction. Output frequency: 60 Hz +/- 1 Hz. Battery low voltage shutdown: 20.0 +/- 0.5 V. No load current: < 0.6 Amps. Full load efficiency: 90%. 1/3 load efficiency: 95%. No load minimum operating temperature: -15 degrees Celsius. Full load maximum operating temperature: 55 +/- 5 degrees Celsius (automatic shutdown). AC Output Socket Type: dual Type 2 -3 prong. High input voltage protection: 30V-34V. Low input voltage shutdown: 20V. UL maximum recommended per outlet 1500W. INSIDE OUR STORE MISSOURI WIND AND SOLAR IN SEYMOUR, MISSOURI. A REAL STORE WITH REAL PEOPLE. YOU CAN ACTUALLY COME IN AND TRY OUR PRODUCTS AND SEE THEM WORKING. It is your responsibility to pay them. Products may be slightly different than the ones pictured. If our supplier runs short of the products shown, we will substitute them for the same quality or better. The item "Grid Tie All In One Charge Controller Board with Aims Power Inverter" is in sale since Tuesday, April 21, 2015. This item is in the category "Home & Garden\Home Improvement\Electrical & Solar\Alternative & Solar Energy\Wind Generators". The seller is "missouriwind" and is located in Seymour, Missouri. This item can be shipped worldwide.

• Brand: Missouri Wind
• Model: Grid tie all in one board with inverter
• MPN: Grid tie all in one board with inverter
• Country/Region of Manufacture: United States
• Type: Wind Turbine and Solar Panel