Solar Grid Tie Inverter MPPT Pure Sine Wave PV Input Battery Adjustable Power. Upgraded the new adjustable power inverter. 1 It adds a solar panel and battery operation mode switch. 2 In battery mode, the knob can switch from 100W to 380W any mobilization. 3 It adds to record each time you turn off the last set of power. PV open voltage range. PV MAX input power(W). MPPT Voltage rangeV. Suitablefor Battery voltage(V). Battery Low Voltage Protection(V). MAX adjustable power(W). MIN adjustable power(W). PV mode AC MAX output W. Battery mode AC output power. 220VAC(185-250VAC) or 120VAC(90-140VAC). 50Hz(4852) or 60Hz(5862). Stable real efficiency / 120V. Stable real efficiency / 220V. Islanding; Short-circuit; Low Voltage; Over Voltage; Over temperature Protection. Monocrystalline, polycrystalline, thin-film solar panels. 22.2×16.2×5.5CM. Packaged separately cartonLxWxH. MPPT Voltage range(V). PV grid-connected inverter operating mode. The grid-tied inverter has an automated working order, without needing to monitor. On detection the power output from solar panels, device will decide if the power was large enough to begin the conversion process. Coversion process includes 5 modes, Startup, Grid-tied begin, Standby, Stop, Fault-find. Startup – When the start button is on, solar panel and grid lines both connected in normal condition, inverter enters working condition. Grid-tied begin – Grid-tied begin mode is when inverter starts to convert the Direct Current fed through from PV solar panel to a stable Alternate Current and flow to the utility grid. To enable the maximum output of energy, the device uses MPPT control technology to track sun rays, this technology promises the maximum efficiency under diferent daylight and temperature conditions. Standby – Standby mode is when device detects insufficient power feeding through from the solar panel, or device detects abnormal status such as voltages, frequencies, and temperatures not in the permitted range, the device enters standby mode. Stop – Insufficient sunlight hence insufficient PV power feeding through to the device and device enters into the standb mode, when this condition continues and DC voltages falls below 12V for over 1 minute, the device will enter Stop mode. When error ocurs, fault find indicator starts flashing, device will enter Stop mode. Please see 3.4 error status on LED indicator. Battery (battery) power output adjustment mode. The adjustable knob on the inverter to the right twist, Battery power adjustment mode opens, The right of the blue LED light on, At this point the PV inverter MPPT tracking function automatically turns off, Low output machine output power of about 100W, the adjustable knob slowly twist to the right, with the output power gradually increases, the limited battery adjustable maximum output power of about 75% of the total power of the inverter (for example, 500W inverter defined variable will be around 370W, 600W inverter will be limited to 450W). When the inverter is connected to the battery discharge the battery voltage is too low, The inverter will automatically stop to protect the battery output voltage is not too low, At this point you can not cut off the DC line between the inverter and battery, You can use other independent solar charge controller to the battery charge, When charging the battery is full, When 26 42V inverter connected to 24V battery:The inverter will automatically start and the net output (for example, Battery voltage into about 21V, the machine will automatically shut down, this time with another charge controller to the battery charge, When charged to about 25V, the machine will automatically begin to work), Charging without human intervention. Battery (battery) mode, a plurality of sub-voltage specifications in the following table. Battery Low voltage protection. Battery high voltage protection. There may be some delays due to flight, holiday, weather, local post, local natural disaster impact. It must also be in the original packaging. This item is in the category “Home & Garden\Home Improvement\Electrical Supplies\Alternative Energy Supplies\Alternative Energy Chargers & Inverters”. The seller is “ginmega” and is located in this country: CN. This item can be shipped worldwide.

• Colour: 500W Adjustable Type
• Input Voltage: PV 26-45V Bat 24V
• Output Voltage: 110Vac(90V-140V)
• Socket Type: USA
• System Configuration: Grid-Tie
• Current Output: Other
• Power Source: Solar
• Inverter Technology: Microinverter
• Size: Standard
• Color: Blue
• Custom Bundle: No
• Current Rating: Other
• Wattage: Other
• MPN: 767098789
• Item Length: Standard
• Brand: Unbranded
• Type: Charger/Inverter
• Current Type: AC/DC
• Voltage: 16-180V
• Model: Other
• Recommended Environment: Indoor/Outdoor
• Features: Durable
• Charging Mode: MPPT (Maximum Power Point Tracking)
• Resistance Properties: Other
• Country/Region of Manufacture: China
• Application: Agriculture/Farming, Aquaculture